Filter
Top Products
BEFORE
YOU BEGIN
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
BOLTS (B)
SPRING
WASHERS (C)
ARC
WASHERS (E)
FLAT
WASHERS (D)
MULTI-GRIP BARS
CONSOLE MAST
PULSE GRIP WIRES
A SS E M B LY ST E P 3
Open HARDWARE BAG FOR STEP 3.
Route PULSE GRIP WIRES from MULTI-GRIP BARS through CONSOLE MAST and up to console hole.
DO NOT PINCH WIRES!
Attach the MULTI-GRIP BARS to the CONSOLE MAST using 2 BOLTS (B), 2 SPRING WASHERS (C) and 2
FLAT WASHERS (D) in each side and 2 BOLTS (B), 2 SPRING WASHERS (C) and 2 ARC WASHERS (E) in
the rear of the MULTI-GRIP BARS.
A
B
C
A SS E M B LY ST E P 4
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
Remove PRE-ATTACHED BOLT & WASHER from RIGHT PIVOT TUBE.
Slide RIGHT PEDAL ARM onto the CRANK and attach by re-inserting PRE-ATTACHED BOLT & WASHER.
Repeat on the other side.
Attach the PEDAL ARM COVER to the RIGHT PEDAL ARM using PRE-ATTACHED SCREW.
Repeat on the other side.
A
B
C
D
E
PRE-ATTACHED WAVY WASHER PRE-ATTACHED BOLT & WASHER
PRE-ATTACHED SCREWPEDAL ARM
PEDAL ARM COVER
CRANK
BOLT (B)
15 mm
Qty: 6
SPRING WASHER (C)
15 mm
Qty: 6
FLAT WASHER (D)
18 mm
Qty: 4
ARC
WASHER (E)
17 mm
Qty: 2
angle view
HARDWARE BAG FOR STEP 3 CONTENTS :
E1201_Rev.1.4.indd 10-11 7/29/08 10:37:31 AM