Filter
Top Products
8
Keyboard Wedge
1. Turn off power to the host device.
2. Plug the interface cable’s modular
connector into the socket on the imager.
3. Disconnect the keyboard from the
host device.
4. Connect the “Y” ends of the
communication cable to the keyboard
and the keyboard port on the host
device. A male/female adapter cable is
supplied with the imager kit.
5. Plug the 12V power supply
6. Check the AC input requirements of the
power supply to verify the voltage
matches the AC outlet. The outlet must
be located near the equipment and be
easily accessible.
into the
power jack on the cable.
7. Connect AC power to the transformer.
8. The MS7580 will start to initialize. The
white and blue LED will alternately fade
on and off for three seconds. When the
imager has finished initializing, the
imager will flash the white LED three
times while simultaneously beeping
three times. The low intensity blue LED
will remain turned on.
9. Turn on power to the host device.
Installation Note
Plugging the imager into a port on the host system does not guarantee that
scanned information will be communicated properly to the host system. The
imager is shipped from the factory configured with default settings. Please refer
to the MetroSelect Single-Line Configuration Guide (PN 00-02544) or
MetroSet2’s help files for instructions on changing the imager’s configuration. In
addition, please check that the imager and host system are using the same
communication protocol.
Figure 6. Keyboard Wedge
The MS7580 requires 12V power to function for Keyboard Wedge operation.
See caution on page 5.