Filter
Top Products
21
56. Wrap the Long Cable (62) around a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the M10 x 78mm Carriage Bolt (84) in the Right
Base (1) with an M10 Nylon Locknut (75). Make
sure the Cable Trap is oriented to hold the
Cable in the groove of the Pulley.
58. Route the Long Cable (62) over a 90mm Pulley
(38). Attach the Pulley to the indicated bracket on
the Right Top Frame (10) with an M10 x 45mm
Bolt (78) and an M10 Nylon Locknut (75).
59. Route the Long Cable (62) over a 90mm Pulley
(38). Attach the Pulley to the indicated bracket on
the Right Top Frame (10) with an M10 x 45mm
Bolt (78) and an M10 Nylon Locknut (75).
60. Thread an M12 Nut (80) onto the Long Cable (62)
as far as it will go. Slide a 50mm Washer (59)
onto the Cable and thread the Cable into the right
Weight Tube (34) until the Cable is tight. Tighten
the Nut against the Washer.
57. Note: The next three steps are shown from the
back of the weight system.
Route the Long Cable (62) under the right stack
of Weights (30) and through the bracket on the
Right Base (1). Attach a 90mm Pulley (38) over
the Cable with an M10 x 45mm Bolt (78) and an
M10 Nylon Locknut (75).
56
57
58
59
60
75
62
84
1
38
75
1
78
30
62
78
10
38
62
78
37
38
75
75
38
62
10
62
80
59
34
61. Locate and open the parts bag labeled “SEAT
ASSEMBLY.”
Attach the Seat (26) with the serial number decal
to the Left Seat Frame (4) with four M6 x 16mm
Screws (79). Attach the other Seat to the Right
Seat Frame (not shown) in the same manner.
61
26
Wide
End
Serial Number Decal
4
79
Seat Assembly