Filter
Top Products
13
20. Lubricate an M12 x 102mm Bolt (81) with grease.
Attach the Press Frame (14) to the Right Base (1)
with the Bolt and an M12 Locknut (95). Make
sure the hole is closer to the indicated side of
the Press Frame. Do not overtighten the
Locknut; the Press Frame must be able to
pivot easily.
22. Press two 50mm Square Inner Caps (43) into the
Leg Lever (18).
Lubricate an M10 x 78mm Bolt (85) with grease.
Orient the Leg Lever (18) as shown and attach it
to the Left Leg (8) with the Bolt and an M10
Nylon Locknut (75). Do not overtighten the
Locknut; the Leg Lever must be able to pivot
easily.
23. Lubricate both axles on the Left Top Frame (11)
with grease.
Slide the Left Fly Pivot (21) onto the indicated
axle on the Left Top Frame (11). Set two 25mm
Retainer Rings (53) on a 25mm Round Outer Cap
(47). Make sure the teeth on the Rings are
toward the Cap, as shown in the inset draw-
ing. Tap the Retainer Rings and Outer Cap onto
the axle. Repeat with the Right Fly Pivot (22).
21. Press a 50mm Square Inner Cap (43) into a
Press Arm (15). Press two 25mm Round Inner
Caps (65) into the Press Arm.
Wet the handles on the Press Arm (15) with
soapy water. Slide two Grips (68) onto the han-
dles.
Attach the Press Arm (15) to the Press Frame
(14) with two M10 x 70mm Bolts (87) and two
M10 Nylon Locknuts (75).
Attach the other Press Arm (15) to the Press
Frame (14) in the same manner.
20
21
22
23
95
43
15
14
Lubricate
Hole
1
65
85
18
75
43
43
8
47
11
Lubricate
Small
Slot
21
53
75
15
14
87
68
Axle
81
22
53
47
Axle