Filter
Top Products
15
28. Wrap the Butterfly Cable (64) under a 90mm
Pulley (38). Attach the Pulley and a Cable Trap
(37) between the second set of holes from the top
of the two Pulley Plates (36) with an M10 x 48mm
Bolt (23) and an M10 Nylon Locknut (75). Make
sure that the Cable Trap is turned to hold the
Cable in the groove of the Pulley.
30. Attach the Butterfly Cable (64) to the Right Fly
Pivot (22) with an M8 x 58mm Shoulder Bolt (89),
two M8 Washers (90), and an M8 Nylon Locknut
(54).
31. Locate the Low Cable (63). Route the Cable
under a 90mm Pulley (38). Attach the Pulley
inside the bracket on the Left Base (2) with an
M10 x 45mm Bolt (78) and an M10 Nylon Locknut
(75).
29. Wrap the Butterfly Cable (64) over a “V”-pulley
(40). Attach the “V”-pulley and a Large Cable Trap
(39) to the bracket on the Left Upright (6) with an
M10 x 60mm Bolt (82) and an M10 Nylon Locknut
(75). Make sure that the Cable Trap is turned to
hold the Cable in the groove of the “V”-pulley.
28
29
30
31
38
37
82
75
64
90
54
22
6
39
40
64
89
38
2
75
78
63
64
23
36
36
75