Filter
Top Products
18
41. Wrap the High Cable (61) over a 90mm Pulley
(38). Attach the Pulley to the Right Top Frame
(10) with an M10 x 45mm Bolt (78) and an M10
Nylon Locknut (75).
43. Route the High Cable (61) up through the Right
Top Frame (10) and over a 90mm Pulley (38).
Attach the Pulley inside the Top Frame with an
M10 x 78mm Bolt (85), two M10 Washers (74),
two 17mm Spacers (58), and an M10 Nylon
Locknut (75).
44. Route the High Cable (61) over a 90mm Pulley
(38) and down through the Right Top Frame (10).
Attach the Pulley inside the Top Frame with an
M10 x 78mm Bolt (85), two M10 Washers (74),
two 17mm Spacers (58), and an M10 Nylon
Locknut (75).
45. Locate the Long Cable (62). Attach the eyelet
on the Cable to the Right Upright (5) with an M10
x 110mm Bolt (88), an M10 Small Washer (33),
and an M10 Nylon Locknut (75). Do not tighten
the Locknut yet.
42. Wrap the High Cable (61) under a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the second set of holes from the top of the
Double “U”-bracket (41) with an M10 x 48mm Bolt
(23) and an M10 Nylon Locknut (75). Make sure
the Cable Trap is turned to hold the Cable in
the groove of the Pulley.
41
42
43
44
45
75
38
10
78
61
37
41
23
74
74
75
38
58
58
75
85
61
38
38
61
10
10
61
75
88
74
74
58
58
85
33
5
62
75