Filter
Top Products
14
24. Press a 50mm Square Inner Cap (43) into a
Butterfly Arm (20).
Wet a Fly Handle (66) and the inside of a Long
Foam Pad (97) with soapy water. Slide the Foam
Pad onto the Handle.
Attach a Fly Handle (66) to the Butterfly Arm (20)
with two M10 x 25mm Button Screws (60) and
two M10 Washers (74).
Repeat this step with the other Butterfly Arm
(not shown). Make sure that the Fly Handle is
oriented as shown in step 25.
25. Lubricate an M10 x 80mm Bolt (86) with grease.
Attach the left Butterfly Arm (20) to the Left Fly
Pivot (21) with the Bolt and an M10 Nylon
Locknut (75).
Attach the right Butterfly Arm (20) to the Right
Fly Pivot (22) in the same manner.
26.
Locate the Butterfly Cable (64). Attach the
Cable to the Left Fly Pivot (21) with an M8 x
58mm Shoulder Bolt (89), two M8 Washers (90),
and an M8 Nylon Locknut (54).
27. Wrap the Butterfly Cable (64) over a “V”-pulley
(40). Attach the “V”-pulley and a Large Cable Trap
(39) to the bracket on the Left Upright (6) with an
M10 x 60mm Bolt (82) and an M10 Nylon Locknut
(75). Make sure that the Cable Trap is turned to
hold the Cable in the groove of the “V”-pulley.
25
26
27
Cable Assembly
IMPORTANT: Refer to the CABLE DIAGRAMS
on pages 27 and 28 for help identifying the
cables.
20
66
97
60
Lubricate
21
22
20
20
54
89
64
82
40
39
64
75
6
90
21
90
86
75
74
43
24