Filter
Top Products
26
5
0. Wrap the Rear Cable (94) under a Small Pulley
(
74). Attach the Small Pulley, a Small Cable Trap
(93), and two Half Pulley Guards (91) at the sec-
ond hole from either end of the two Pulley Plates
(92) with an M10 x 48mm Bolt (125) and an M10
N
ylon Locknut (153).
M
ake sure that the Cable
Trap and the Half Pulley Guards are oriented
as shown.
50
51. Attach the Rear Cable (94) inside the Weight
Carriage Frame (18) with an M10 x 55mm Bolt
(127), two M10 Washers (148), and an M10
Nylon Locknut (153).
51
52. Identify the Low Cable (80). Route the threaded
end of the Cable through the Foot Plate (15) and
the Center Upright (13).
W
rap the Low Cable (80) under a Large Pulley
(165). Attach the Large Pulley inside the Center
Upright (13) with an M10 x 93mm Bolt (129), two
M10 Washers (148), two M10 x 25mm Spacers
(169), and an M10 Nylon Locknut (153).
52
18
127
153
148
148
94
153
80
15
129
169
169
148
13
91
91
9
2
74
93
125
1
53
94
165
148