Filter
Top Products
10
10. Slide two Foam Pads (35) onto the Front Leg (3).
Then, press two Pad Caps (37) into the Foam
Pads.
Insert the two Pad Tubes (159) into the Leg Lever
(4). Slide two Foam Pads (35) onto each Pad
Tube. Then, press a Pad Cap (37) into each
Foam Pad.
10
9. Slide the Weight Spacer (160) onto the Leg Lever
(4).
Grease the outside of the barrel of an M10 x
8
3mm Bolt Set (118). Attach the Leg Lever (4) to
the Front Leg (3) with the Bolt Set. Make sure
that the barrel of the Bolt Set is inserted
through both sides of the bracket on the Leg
Lever.
Attach the Curl Bar Pin/Tether (36) to the Leg
Lever (4) with an M4 x 16mm Self-tapping Screw
(147).
9
11. Insert the Curl Bar (40) into the 50mm x 1.5mm
Connecting Cap (42) as shown. Next, tighten an
M4 x 30mm Self-tapping Screw (79) with a Curl
Bar Spacer (178) into the slot in the Connecting
Cap and into the hole in the Curl Bar.
Attach the 50mm x 1.5mm Connecting Cap (42)
to the Curl Bar Frame (5) with an M8 x 65mm
Bolt (146), two M8 W
ashers (164), and an M8
Nylon Locknut (170).
11
4
118
3
118
35
35
35
35
35
35
37
37
37
37
37
3
4
159
40
36
42
79
5
170
164
164
146
178
147
160
Grease