Filter
Top Products
7
3. Identify the Right Upright (86) and the Right
Upright Spacer (92).
Insert the Upright Wire (97) through the Right
Upright Spacer (92) as shown. Then, set the
Right Upright Spacer on the Base (95). Be care-
ful not to pinch the Upright Wire.
Have a second person hold the Right Upright
(86) near the Base (95). See the inset drawing.
Tie the wire tie in the Right Upright securely
around the end of the Upright Wire (97). Then,
pull the other end of the wire tie until the Upright
Wire is routed completely through the Right
Upright.
95
97
86
92
97
3
2
. Attach a Wheel (96) to the Base (95) with a 3/8"
x 2" Bolt (5) and a 3/8" Nut (9). Do not over-
t
ighten the Nut; the Wheel must turn freely.
See the inset drawing. Cut the plastic tie near
the Upright Wire (97).
5
9
2
96
Wire
Tie
Wire Tie
86
97
95
Cut
97
4. Hold a Bolt Spacer (25) inside the lower end of
the Right Upright (86). Next, insert a 3/8" x 4
1/2" Bolt (6) with a 3/8" Star Washer (10) into
the Right Upright and the Bolt Spacer. Repeat
this step with a second Bolt Spacer (25), 3/8"
x 4 1/2" Bolt (6), and 3/8" Star Washer (10).
Then, set the Right Upright in the Right Upright
Spacer (92). Be careful not to pinch the
Upright Wire (97).
Partially tighten the 3/8" x 4 1/2" Bolts (6); do
not fully tighten the Bolts yet.
92
86
6
4
97
10
25