Filter
Top Products
ASSEMBLY
T
o hire an authorized service technician to assemble the treadmill, call 1-800-445-2480.
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
b
elt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of
the walking belt or the shipping carton. This is normal and does not affect performance. If there is lubricant on top
of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex keys and your own Phillips screwdriver ,
adjustable wrench , rubber mallet , and scissors .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it is preattached
to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assem-
bly. Extra hardware may be included.
#8 x 3/4" Screw (1)–4
3/8" Nut (9)–5
#8 x 1" Tek Screw (4)–4
Base Foot Spacer
(11)–2
3/8" Star Washer
(10)–10
3/8" x 3/4"
Patch Bolt (8)–2
#8 x 1/2" Screw
(2)–12
1/4" x 1/2"
Bolt (3)–2
3/8" x 2" Bolt (5)–5
3/8" x 1 1/4" Bolt (7)–4
3/8" x 4 1/2" Bolt (6)–4
1. With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (57) so that the treadmill is more stable;
do not fully fold the Frame yet.
Cut the shipping tie securing the Upright Wire
(97) to the Base (95). Locate a tie in the indi-
cated hole in the Base, and use the tie to pull
the Upright Wire out of the hole.
Attach a Base Foot (93) to the Base (95) in the
location shown with a #8 x 1" Tek Screw (4) and
a Base Foot Spacer (11). Then, attach another
Base Foot (93) with only a #8 x 1" Tek Screw (4).
95
4
57
93
1
93
4
97
Hole
11
6