Filter
Top Products
12
1. Make sure that the power cord is unplugged.
Remove the indicated #8 x 1/2" Screw (2) from
the Access Door (123) on the back of the con-
sole assembly.
2. Next, hold the receiver so that the antenna is
oriented as shown. Peel the paper backing off
the pad on the bottom of the receiver. Press the
receiver onto the Access Door (123) in the loca-
tion shown.
3. Connect the wire on the receiver to the wire ex-
tending from the console assembly. Make sure
that no wires are pinched. Reattach the
Access Door (123) to the console assembly with
the #8 x 1/2" Screw (2). Discard the other wires
included with the receiver.
If you purchase the optional chest pulse sensor (see page 22), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
3
Wires
123
Antenna
2
Receiver
123
2
Console
Assembly
1
123
2
Console
Assembly