Filter
Top Products
8
8. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrenches for adjustment purposes. To protect the floor or carpet from damage, place a mat under the treadmill.
6. After the treadmill is moved to the location where it will
be used (see HOW TO MOVE THE TREADMILL on
page 30), make sure that both Rear Feet (5) and both
front Wheels (not shown) rest firmly on the floor. If the
treadmill rocks slightly, loosen the Rear Foot Locknut
(111) above the right Rear Foot. Turn the right Rear
Foot clockwise or counterclockwise until the rocking
motion is eliminated. Then, tighten the Rear Foot
Locknut.
5
111
6
5. Plug the indicated end of the Power Cord (48) fully into
the treadmill as shown.
48
4. See step 1. While a second person holds the Uprights
(95, 97), remove the two Upright Bolts (96).
Slide the Uprights (95, 97) fully onto the brackets on the
Frame (not shown). Be careful to avoid pinching your
hands or the Wire Harness (not shown). Attach each
Upright with four Upright Bolts (96) as shown. Firmly
tighten all eight Upright Bolts.
Firmly tighten the eight Handrail Bolts (99).
5
111
99
99
99
95
96
96
97
4
7. Note the location of the 75 ohm antenna terminal on
the treadmill. For the television to operate properly,
an antenna, a CATV cable, or a VCR must be con-
nected to the 75 ohm antenna terminal.
If you are using an antenna, it must be properly con-
nected and adjusted for optimal reception. See AN-
TENNA CONNECTIONS on page 9 to properly connect
an antenna. If you are using a CATV cable, see CATV
CABLE CONNECTION on page 9. If you are using a
VCR, see HOW TO CONNECT A VCR on page 9. The
VCR must be turned on, a videocassette must be prop-
erly inserted, and the VCR must be playing. See your
VCR user’s manual for operating instructions.
75 Ohm Antenna
Terminal
5
7