Filter
Top Products
1190 Sr Owner’s Manual
39
Maintenance
CAUTION – FOR SAFE OPERATION
Always inspect hardware prior to any exercise session. Look for loose hardware, loose
pedals, loose cranks and frayed wires. Repair or replace any damaged or worn parts,
tighten all loose hardware.
As part of Diamondback’s normal installation and set-up process, all pedal cranks must
be tightened after 8 to 10 hours of initial riding to ensure parts are properly seated to
axle. This is standard initial “break-in” service, which must be performed after the first
8 to 10 hours of use. Un-tightened pedal cranks may become loose, causing damage,
which may void the warranty.
After exercising, always wipe down your unit. Perspiration that continuously settles on
frame, pads or casing may eventually cause rust or damage to the unit. Damage result-
ing from lack of proper maintenance will not be covered under warranty. To clean
pads, use a mild soap and warm water. Dry with a clean towel.
If noises develop or malfunctions occur, contact your authorized Diamondback Fitness
dealer.
1190SROM 9/22/06 1:51 PM Page 41