Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
AJ0975
10
Resetting Air Circuit
The air circuit must be reset before press can be used.
Resetting is required if:
● Press has been shut down.
● Any safety bar or red emergency stop button has
been activated.
● Gauge indicates 0 air pressure.
To reset air to press:
Move buck to dressing position by hand.
Turn red emergency stop button in direction of arrows
until it pops up.
Press reset button. Air should reset and line pressure
(approximately 65 psi [4.48 bar]) should register on
gauge.
NOTE: If press does not reset, call a qualified
service technician.
Pressing Short Sleeve Shirts
Sleeve extender arms are not used when a short sleeve
shirt is dressed on the buck. The operator should turn
the steam timer selector switch to the off position to
stop live steam and sleeve blower air through sleeve
armhole.
To avoid possible injury:
• ALWAYS turn STEAM Timer Selector
switch OFF when pressing short sleeve
shirts.
• ALWAYS stand clear of live steam when
sending buck into pressing cabinet.
W441
CAUTION