Filter
Top Products
CC-TR100
1514
CC-TR100
!
Using the HR strap
1. Adjust the length of the HR strap to fit your chest size. Fastening the strap too tightly may
cause discomfort.
2. Fasten the hook of the transmitter.
NOTE: Secure the transmitter with the cloth loop.
3. Insert the electrode pads (one on the left and the other on the right) between the HR strap
and the body, and secure the electrode pad onto the HR strap using the hook.
Ensure that the rubber part of the electrode pad is in direct contact with the body.
!
If the electrode pads are loose please wear the chest strap as indicated below.
Neck strap
Hook
Cloth ring
Heart rate
Electrode pad
HR strap
Electrode pad
Transmitter
Cloth loop
Shift the HR Strap to
adjust its position
When a sports bra is worn
NOTE: Wearing the heart rate sensor on a sports bra requires the optional neck strap.
1. Attach the strap to the transmitter as shown in the picture below, looping the strap through
the hole in the transmitter hook.
2. Wearing the neck strap, adjust the length to bring the transmitter to the correct height.
3. Attach the electrode pads to the sports bra using the hook on the pad, making sure the
rubber part of the electrode pad itself is in direct contact with the body.
Heart rate sensor test
1. Wear the heart rate sensor.
2. Mount the main unit to the HR receiver, and stand so that the HR transmitter is within 20-80 cm.
NOTE: Be sure to attach the main unit to the HR receiver. Signals from the heart rate
sensor cannot be received by the main unit alone.
3. When the
icon flashes and the heart rate is indicated on Display-2, the heart rate sen-
sor is operating properly.
NOTE: • The heart rate sensor will start transmission approximately three seconds after it has
stabilized. Therefore, a short time lag occurs before the
icon begins to blink.
• If the
icon does not flash, move the electrode pad little by little to find the
optimum position for the heart rate reception. Dryness may make measurement
difficult. Moistening the electrode pad allows easier measurement.
Heart Rate Function
Heart rate is measured when the heart rate sensor is worn on the chest.
NOTE: Heart rate sensor reception range is approximately 20 cm and 80 cm.
Before wearing the heart rate sensor
Warning!!! This product must NOT be used by those who have a pacemaker.
NOTE: • Wear the heart rate sensor in the center of the chest. The rubber part of the electrode
pad must be in direct contact with the skin.
• To avoid measurement errors, it is recommended to moisten the electrode pads with
water.
• If your skin is ultra-sensitive, the electrode pad may be moistened with water and
worn on a thin undershirt.
• Chest hair may interfere with the measurement.
• Using the heart rate sensor together with other cordless devices may cause interfer-
ence with the data transmission.
Wearing the heart rate sensor
Besides using the conventional chest strap, it can be worn directly attached to a sports bra
using an optional neck strap.
NOTE: • Ensure that the rubber part of the electrode pad is in close or direct contact with the
body.
• Some sports bras cannot be worn with the heart rate sensor.
• Wearing the heart rate sensor on top of your undershirt may produce measurement
errors. Measurement errors may also occur if the skin is exceptionally dry. To avoid
errors, moisten the rubber part of the electrode pad.
HR strap
Heart rate sensor
Transmitter
Electrode pad
Cloth loop