Getting Acquainted
4
1
D Attach the ferrite core to the loop.
E Attach the network interface cable to the 10BASE-T/100BASE-TX connector
on the right side of the back cover of the machine.
Reference
See P.1 “Connecting the Machine” to make sure of the position of the
10BASE-T/100BASE-TX port.
Note
❒ Make sure that the cable is connected to the 10BASE-T/100BASE-TX port.
❒ Do not connect the cable into the Fax port.
F Connect the other end of the cable into the network.
Button and indicators on the network interface board
1. Button
Press this button for more than 2 seconds
to print “Network Configuration Page”.
Press this button more than 5 seconds to
print “System Log Information”.
2. Indicator (orange)
Stays on while the network interface
board is working.
3. Indicator (green)
Stays on while the 100BASE-TX is work-
ing. Stays off while 10BASE-T is working.
4. Indicator (green)
Stays on while the machine is in a net-
work enviroment.
TAHX010E
1
2
3
4
