51
FUNCTION SETUP
EN
Set up the network connection settings in order to use BD-
Live, DLNA home media server or network update
function.
After you enable a network connection or change the
network settings, always perform the connection test to
check if the connection is correctly made.
1 In stop mode, press [SETUP].
2 Use [K / L] to select , then press [ENTER].
3 Use [K / L] to select “Others”, then press [ENTER].
4 Use [K / L] to select “Network Connection”, then
press [ENTER].
5 Use [K / L] to select “Connection Test”, then press
[ENTER].
Connection test will start automatically and the test result
will appear right after the connection test finishes.
Press [ENTER] to go to the list of network status
confirmation screen.
6 Press [ENTER] to go back to the previous screen, or
press [SETUP] to exit.
Network settings are set to the following settings initially.
(In most cases, you can connect to the Internet without
making any changes to the default settings.)
If you want to set
the network settings back to the default
settings as above (except “BD-Live Setting”), follow the
procedure below.
1 Follow steps 1 to 4 in “Connection Test” on page 51.
2 Use [K / L] to select “Enable(Easy)”, then press
[ENTER].
•The unit will star t the connection test automatically
and the test result will appear right after the test
finishes.
• After the connection test finishes, press [ENTER] to go
to network status confirmation screen.
3 Press [ENTER] to activate the network settings and
set the network connection automatically. Press
[SETUP] to exit.
In following cases, select “Enable(Custom)” to set each
setting as necessary.
• IP Address Setting / DNS Setting
1 Follow steps 1 to 4 in “Connection Test” on page 51.
2 Use [K / L] to select “Enable(Custom)”, then press
[ENTER].
3 Use [K / L] to select “IP Address Setting”, then press
[ENTER] repeatedly to select the desired setting.
Network Connection
Connection Test
• “Testing...” : The test is in progress.
• “Pass” : Connection test is successfully
completed.
• “Fail” : Connection test failed. Check the
connection settings.
Note
• If the connection test passes, you can enjoy the BD-
Live, DLNA home media server feature or network
update function, using the Internet without making
any extra settings.
• If the connection test fails, you may need to change
the MAC address settings of your router.
• “Connection Test” is not avai
lable when “Disable” is
selected in “Network Connection”.
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
Others
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
Connection Test
then press ‘ENTER’.
Enable(Easy)
-IP Address Setting Auto(DHCP)
-DNS Setting Auto(DHCP)
-Proxy Setting Do Not Use
-Connection Speed Auto
-BD-Live Setting Allow
Note
•The setting of “BD-Live Setting” will not be set back
to the default, even if you follow the procedure.
Enable(Custom)
-When connection test failed with the setting of
“Enable(Easy)”.
-When instructed by your Internet service provider to
make specific settings in accordance with your
network environment.
“Auto(DHCP)” : If your router has DHCP server function,
select “Auto(DHCP)”.
“Manual”:If your router does not have DHCP
server function, select “Manual”.
