12
FUNCTION OVERVIEW
EN
Install 2 R6 (1.5V) batteries matching the polarity indicated
inside battery compartment of the remote control.
Keep in mind the following when using the remote
control:
• Make sure that there are no obstacles between the
remote control and the infrared sensor window on the
unit.
•
Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the infrared
sensor window of the unit.
• Remote control for different devices can interfere with
each other. Avoid using remote control for other device
located close to the unit.
• Replace
the batteries when you notice a fall off in the
operating range of the remote control.
•The maximum operable ranges from the unit are as
follows.
In stop mode and “Mode Select” is set to “Network”,
opening screen is displayed.
“Home Network”: To access the l
ist of DLNA home server
Installing the Batteries in the Remote Control
1) Open the cover.
2) In sert batteries.
Make sure to match + and ] on the batteries to the
marks indicated in the battery compartment.
3) Close the cover.
Note
Incorrect use of batteries can result in hazards such
as leakage and bursting. Please observe the
following:
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
Although they may look similar, different batteries
may have different
voltages.
• Make sure that the + and - ends of each battery
match the indications in the battery compartment.
• Remove batteries from battery compartment that is
not going to be used for a month or more.
• When disposing of used batteries, please comply
with governmental regulations or
environmental
public instruction’s rules that apply in your country
or area.
• Do not recharge, shor t-circuit, heat, burn or
disassemble batteries.
Using a Remote Control
Opening Screen
30˚
30˚
Approx.
5 m
Infrared sensor window
BD-SP808
Home Network
