A SERVICE OF

logo

Open as PDF
next previous
20
CONNECTIONS
EN
You can use the following multi-room kits to control the BD-SP808 when it’s out of range of the remote controller:
• Multiroom kits such as those made by Niles and Xantech.
If another AV component is out of range of its remote controller, you can use
a commercially available IR emitter to
retransmit the remote controller signals received at the BD-SP808's IR IN jack, as shown below.
Connect the IR emitter to the BD-SP808's IR OUT jack, and place the IR emitter in front of the other AV
component's
remote control sensor (usually located on its front panel), as shown below. See the instructions supplied with the IR
emitter.
Only remote controller signals received by the BD-SP808's IR IN jack are fed through to the IR OUT jack. Signals picked up
by the BD-SP808's remote control sensor are not output.
Controlling AV Components that are Out of Range
IR
IN
IR
IN
RS232
Controlling Other Out-of-Range AV Components
IR IN
Other
compo-
nent
Remote controller
IR emitter
Connecting
block
Signal flow
IR OUT
BD-SP808
BD-SP808
IR
IN
from
connecting block
Miniplug cable
Miniplug
IR emitter
Signal flow
IR emitter
Remote control
sensor
Other component