Commander GP User Guide
Issue code: gpxu2
3-42 Setting Up the Drive
Pr Function User
value
0.00 Configuration and saving
0.01 Minimum frequency clamp
0.02 Maximum frequency clamp
0.03 Acceleration rate
0.04 Deceleration rate
0.05 Reference selector (limited settings)
0.06 Current limit
0.07 Voltage mode selector
0.08 Boost voltage
0.09 Dynamic V/f select
0.10 Estimated motor speed [M]
[M] indicates the parameter is for monitoring only
For descriptions of these parameters, see
Appendix D Menu 0 Parameters.
List of parameters specific to Macro 6
Pr Function User
value
0.11 Pre-ramp reference [M]
0.12 Post-ramp reference [M]
0.13 Motor active-current [M]
0.14 Limit forward indicator [M]
0.15 Run forward indicator [M]
0.16 Run reverse indicator [M]
0.17 Limit reverse indicator [M]
0.18 Stop mode selector
0.19 Hold zero speed enable
0.20 Limit deceleration rate
0.21 Limit forward invert
0.22 Limit reverse invert
0.23 (Not used)
0.24 (Not used)
0.25 (Not used)
0.26 (Not used)
0.27 (Not used)
0.28 (Not used)
0.29 (Not used)
0.30 (Not used)
Pr Function User
value
0.31 Macro number [M]
0.32 Serial comms. mode
0.33 Drive rated current (FLC) [M]
0.34 User security code [M]
0.35 Keypad reference [M]
0.36 Serial comms. baud rate
0.37 Serial comms. address
0.38 Power up parameter display select
0.39 Synchronize to a spinning motor
0.40 Autotune
0.41 PWM switching frequency selector
0.42 Motor – number of poles
0.43 Motor – power factor
0.44 Motor – rated voltage
0.45 Motor – rated full load RPM
0.46 Motor – rated current
0.47 Motor – rated frequency
0.48 Drive operating mode selector
0.49 Security status [M]
0.50 Drive software version [M]
