Commander GP User Guide
Issue code: gpxu2
3-12 Setting Up the Drive
Pr Function User
value
0.00 Configuration and saving
0.01 Minimum frequency
0.02 Maximum frequency
0.03 Acceleration rate
0.04 Deceleration rate
0.05 Reference selector
0.06 Current limit
0.07 Voltage mode selector
0.08 Boost voltage
0.09 Dynamic V/f select
0.10 Estimated motor speed [M]
0.31 Macro number [M]
0.32 Serial comms. mode
0.33 Drive rated current (FLC) [M]
0.34 User security code [M]
0.35 Keypad reference [M]
0.36 Serial comms. baud rate
0.37 Serial comms. address
0.38 Initial parameter displayed
0.39 Synchronize to a spinning motor
0.40 Autotune
0.41 PWM switching frequency selector
0.42 Motor – number of poles
0.43 Motor – power factor
0.44 Motor – rated voltage
0.45 Motor – rated speed
0.46 Motor – rated current
0.47 Motor – rated frequency
0.48 Drive software build number [M]
0.49 Security status [M]
0.50 Drive software version [M]
[M] indicates the parameter is for monitoring only
For descriptions of these parameters, see Appendix D Menu
0 Parameters.
List of parameters specific to Macro 1
