When you hold down the [A/V Mute] button on the top of the projector
for approximately three seconds, a pattern is projected and Auto Calibration
begins.
If Auto Calibration fails, an error message is displayed. Perform Manual
Calibration.
The cursor location and pen position should match after calibration. If not,
you may need to perform Manual Calibration.
a
• You can perform Auto Calibration from the Configuration menu.
Perform operations as instructed in the message displayed.
s Extended - Easy Interactive Function - Auto
Calibration p.123
• You cannot perform Auto Calibration from the remote
control's [A/V Mute] button. When you hold down the remote
control's [A/V Mute] button, the Projection changes.
s Extended - Projection p.120
Calibrating Manually
If the cursor location and pen position do not match after auto calibration,
you can calibrate manually.
a
Press the [Menu] button, select the Extended menu, and press
the [Enter] button.
b
Select the Easy Interactive Function setting and press the [Enter]
button.
Using the Interactive Pens
69
