Attention
The interactive features operates by infrared communication. Note the
following points when installing the projector.
• Make sure there is no strong light or sunlight shining on the Easy Interactive
Function receiver, the projection screen, the projector itself, or the rear of the
projector.
• Do not install the projector in direct sunlight through a window. This could
cause the interactive features to malfunction.
• If there is any dust stuck to the Easy Interactive Function receiver, it could
interfere with infrared communication and you may not be able to use the
function normally. Clean the receiver if it is dirty.
• Do not put paint or any stickers on the cover of the Easy Interactive
Function receiver.
• Install the projector so that the Easy Interactive Function receiver is not too
close to fluorescent lights. If the surrounding area is too bright, the
interactive features may not operate correctly.
• When using the interactive features, do not use an infrared remote control or
microphone in the same room. The Easy Interactive Pen could malfunction.
• Do not use devices that generate powerful noise, such as rotary devices or
transformers, near the projector. You may not be able to operate the
interactive features.
a
• When using the interactive features, install so that the projected
screen is a rectangle without any distortion.
• When using the interactive features in the same room as multiple
projectors, Easy Interactive Pen operations may become unstable. In
this situation, connect the optional Remote control cable set
(ELPKC28) to the projectors, and change Sync of Projectors to
Wired from the Configuration menu.
s "Connecting Multiple Projectors (EB-536Wi only)" p.38
s Extended - Easy Interactive Function - General - Advanced -
Sync of Projectors p.123
Installing the Projector
25
