Weider XP600 Fitness Equipment User Manual


 
insert the connector of the lower wire harness (A)
into the socket of the Upper Wire Harness (13),
The connector should slide easily into the sock-
et and snap into ptace, if the connector does not
slide easily and snap into place, turn the connector
over and then insert it,
Make sure that the connector and wire appear as
shown in the inset drawing, IF THE CONNEC-
TOR IS NOT INSERTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON,
Put1 the excess lower wire harness (A_ out of
the Mech Assemb!_} and push it and the
U_j0er Wire Harness (_ into the U_
insert the Mech Assembly (6) into the Base (1),
Attach the Mech Assembly to the Upright (3) with
a 1/2" x 66mm Carriage Bolt (79) and a 1/2"
Nylon Jamnut (78), Do not tighten the Locknut
yet.
Attach the Mech Assembly (6) to the Base (1)
with four M10 Nylon Locknuts (71),
Tighten the 1/2" Nyton Jamnut (78),
Press the Front Leg Foot (29) onto the bottom of
the Front Leg (31), Note that the front of the
Front Leg Foot is tatter than the back.
Attach the Bench Rail (23), with the hook on the
bottom, to the Front Leg (31) with two MIO x
53mm Carriage Bolts (91) and two MIO Nylon
Locknuts (71),
Grease an MIO x 103mm Bolt (86) using the
included grease pack, Attach the Bench Rail (23)
to the Upright (3) with the Bolt and an MIO Nylon
Locknut (71), Make sure the Bolt is inserted
through the indicated hole in the Bench Rail,
Do not overtighten the Locknut; the Bench
Rait must be aMe to pivot easity,
Tighten the Storage Knob (26) into the Upright (3)
and the Bench Rail (23),
78
1
71
A
13
71
23
'\
G rease
8