17, HoUda Large Pulley (17) inside the upper came
(B), Attach the Pulley to a Pulley Bracket (10)
with an M12 x 58mm Button BoUt(81) and an M12
NyUon Locknut (72), Make sure that the cabJe is
routed as shown in the CABLE DIAGRAM on
page 18.
Screw two 3/8" x 38mm Tension Screws (108)
into the two Pulley Brackets (10) a coupUe of
turns, Make sure the hexagonaJ holes in the
Screws are on the outside of the Brackets.
Tighten the two Screws an equal number of
turns.
18, Attach the Backrest (40) and the Backrest
Backing (39) to the Backrest Frame (36) with four
M6 x 45mm Screws (98),
19, Attach the two Guard Hates (63) to the inside of
the Backrest Frame (36) with four M4 x 16mm
Screws (103),
20, Unsert the rod on the Backrest Frame (36) into the
sUotin the Seat Carriage (48). Hold the Backrest
Frame vertically over the Seat Carriage and
slide the rod into the slot, as shown in the
inset drawing.
18
19
2O
10
B
/
/
1O8
17
4O
36
i
Rod //
36
.Slot
48
12