Weider XP600 Fitness Equipment User Manual


 
21, Locate the Leg Lever CabJe (62), which has two
ends that are the same iength and a third end
that is ionger,
Route the iongest end of the Leg Lever CaMe
(62) through the hob in the Front Leg (31), and
attach it inside of the shot in the Leg Lever (32)
with an MIO x 58mm Boit (94) and an MIO Nyion
Locknut (71),
22, Attach a Smali Pulley (16) inside of the homein
the Front Leg (31) with an MIO x 91mm Boit (92),
two 26mm Spacers (35), two MIO Washers (73),
and an MIO Nyion Locknut (71), Make sure the
Pulley is above the Leg Lever Cable (62}.
SHde the two free ends of the Leg Lever CaMe
(62) onto the hook weided to the bottom of the
Bench Rail (23),
23, SHde two Foam Pads (28) onto the tube on the
Front Leg (31), Press two 19mm Round inner
Caps (33) into the ends of the tube,
Repeat this step with the Leg Lever (32}.
24, Adjust the tension on the upper cable (not shown)
as described in UPPER CABLE ADJUSTMENT
on the following page,
21
94
22
92
62
31
32
35
31
16
71
62
\
32
28
25. Make sure that all parts have been properly tightened, The use of the remauning parts will be explained in
ADJUSTMENTS, beginning on page 15,
Before using the resistance system, pull the long cable a few times to be sure that it moves smoothly over
the pulleys, if the cable does not move smoothly, find and correct the problem, mMPORTANT: mfthe cables
are not properJy installed, they may be damaged when heavy resistance is used. See the CABLE
DIAGRAM on page 18 for proper cable routing.
13