Filter
Top Products
MakeThings Easier for Yourself
This manual is designed to ensure that the resist-
ance system can be assembUed suceessfuUiy by
most peopb, However, it is important to realize
that the versatile resistance system has many
parts and that the assembly process will take
time, Most people find that by setting aside plenty
of time. assembly wiUigo smoothly.
Before beginning assembly, carefully read the
following information and instructions:
Assembly requires two persons,
Place all parts in a cleared area and remove the
packing materials, Do not dispose of the packing
materials until assembly is completed,
• For help identifying small parts, use the PART
IDENTIFICATION CHART. Note: Some small
parts may have been pre-attached for shipping, if
a part is not in the parts bag, check to see if it
has been pro-attached,
Tighten all parts as you assemble them, unless
instructed to do otherwise.
, As you assemble the resistance system, make
sure all parts are oriented as shown in the draw-
ings,
The included Allen wrenches ii-- [i_and
the following tools (not included} are required
for assembly:
Two adjustable wrenches
One rubber mallet
One standard screwdriver _._
• One Philtips screwdriver _C__)
Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly wiii be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches,
Before beginning assembly, make sure that
you have read and understand the informa,
tion in the box above.
Attach a Wheel (21) to the Base (1) with an MIO
x 108mm Button Bolt (90), three MIO Washers
(73), and an MIO Nylon Locknut (71). Do not
overtighten the Locknut; the Wheel must be
able to turn easily.
Attach the other Wheel (21} to the Base (!} in
the same manner.
Attach two Plastic Feet (19) and two Large Plastic
Feet (20) to the Base (1) with four M4 x 16mm
Screws (103).
103 _-_j,
71 73
103
73
21
90
6