Filter
Top Products
TROUBLESHOOTmNG
CLEANmNG THE BAR GUmDES
Over time, dust may build up on the Bar Guides (55),
causing a squeaking noise as the resistance system
is used, Hfthis occurs, wipe off the Bar Guides with a
damp cHothand a mild, non-abrasive detergent, Do not
use soHvents,
ADJUSTING THE RESISTANCE
When the resistance setting changes, the motor wHH
be heard, To prevent damage to the motor, do not
pull any of the cables wMle the resistance setting
is changing, Hfthe motor has difficuHty adjusting the
resistance HeveHand no came is being puHHed,there
may be too much tension on the upper came (B),
Adjust the tension as described bellow,
To decrease the tension on the upper came (B), turn
the two 3/8" x 38mm Tension Screws (108) twice,
countercHockwise, SeHect the desired resistance set-
ting, Repeat this step if necessary,
1O8
19