Filter
Top Products
10, Attach the Lat Tower (5) to the Upright (3) with
four MIO x 25mm Screws (100) and four MIO
Lock Washers (74),
Hug the Upper Wire Harness (13) into the
Console (53), Push a!l of the excess wire into
the Upright (3). Make sure the wire does not
get pinched. Attach the ConsoUe to the Upright
with two M4 x 16mm Screws (103),
11, Attach two EyeboUts (51) to the Lat Tower
Crossbar (49) with two M8 Washers (76) and two
M8 NyUon Locknuts (70),
Attach the Lat Tower Crossbar (49) to the Lat
Tower (5) with two MIO x 65mm Button BoUts
(96), two MIO Washers (73), and the Crossbar
Cover (50), Make sure that the Eyebolts (51}
are oriented as shown in the inset drawing, if
they are not, turn the Lat Tower Crossbar
around and reattach it.
12, Attach a Large Pulley (17) and the Pulley Hate
(18) to the Upright (3) with an M12 x 62mm
Button BoUt(80) and an M12 NyUonLocknut (72),
Do not tighten the Locknut yet.
10
11
12
74 _
103
96
51
49
80
\
17
18
10