Filter
Top Products
13. Pull the upper cabb (B), which is attached inside
of the Mech Assembly (6), up between the
Upright (3) and the Pulby Hate (18).
Attach another Large Pulby (17) between the
Upright (3) and Pulby Hate (18) with an M12 x
62mm Button Bolt (80) and an M12 Nylon
Locknut (72). Make sure that the upper carte
(B} is between the two Pulteys.
Hold the 38mm Spacer (54) inside the loop of the
upper cabb (B), and between the Upright (3) and
the Pulby Hate (18). Attach the Spacer with an
M10 x 58mm Button Screw (85). Make sure the
ends of the cabJe do not wrap around each
other below the Spacer and the Large Pulleys
(17} used in steps 12 and 13 (refer to the
CABLE DIAGRAM on page 18}.
Tighten the M!2 Nylon Locknuts (72) used in
steps 12 and 13.
14. Attach a Small Guide Spacer (56), a Large Guide
Spacer (57), and two Bar Guides (55) to the Lat
Tower (5) with an M10 x 152mm Bolt (83). Do not
tighten the Bott yet.
Pull the upper cabb (B) up between the Bar
Guides (55). Press the metal cover on the cabb
into the groove in the Block Spacer (58). Attach a
Small Guide Spacer (56), the Block Spacer, the
two Bar Guides, an M10 Thick Washer (75), and
the two Tethers (61) to the Lat Tower (5) with
another M10 x 152mm Bolt (83). Do not tighten
the Bott yet.
15. insert the Resistance Bar (9) between the Bar
Guides (55), and center it on the Block Spacer
(not shown).
Press a Pulley Bracket (10) onto the Resistance
Bar (9). Attach a Tether (61) to the Pulley Bracket
at the upper hob, with an MI0 x 63mm Button
Bolt (82), an MI0 Thick Washer (75), and an MIO
Nylon Locknut (71).
Repeat on the other side of the Resistance
Bar (9). Then, tighten the M1O x 152mm Bolts
(83} used in step 14.
16. Hold a Large Pulley (17) inside the upper cable
(B). Attach the Pulley to a Pulley Bracket (10)
with an M12 x 58mm Button Bolt (81) and an M12
Nylon Locknut (72). Make sure that the came is
routed as shown in the CABLE DIAGRAM on
page 18.
13
14
16
8O
18
i
6
55
57
56
B
56 58
61
81
\
83
Metal
83
Cover 75
61
71
\
75
\
10
82
11