Filter
Top Products
8
10.
Press a 50mm x 70mm Inner Cap (22) into the
end of the Right
T
op Frame (8).
Attach the Right Top Frame (8) to the Right
Upright (6) with two M10 x 90mm Bolts (59), a
Support Plate (21), and two M10 Nylon Locknuts
(70).
Attach the Right
T
op Frame (8) to the Left
Top
Frame (3) with two M10 x 70mm Bolts (81), two
M10 Washers (75), and two M10 Nylon Locknuts
(70).
Do not tighten the M10 Nylon Locknuts (70)
yet.
9. Press two 50mm x 70mm Inner Caps (22) into
the ends of the Left Top Frame (3).
Attach the Left Top Frame (3) to the Left Upright
(7) with two M10 x 90mm Bolts (59), a Support
Plate (21), and two M10 Nylon Locknuts (70). Do
not tighten the Locknuts yet.
8. Slide the eight Weights (72) onto the Weight
Guides (20) with the pin grooves on the side
shown.
Press the W
eight Tube Bumper (32) into the bot-
tom of the Weight Tube (82). Insert the Weight
Tube into the center hole in the stack of Weights
(72). Be sure the Weight Tube is oriented as
shown.
Lubricate the indicated holes in the Top Weight
(74). Slide the Top Weight onto the Weight
Guides (20), with the pin groove on the bottom.
72
32
74
20
82
8
Lubricate
Pin
Groove
Holes
22
70
70
59
3
21
22
7
9
6
59
22
70
70
70
3
75
81
8
21
10