Filter
Top Products
12
23. Locate the Leg Press Cable (95). Attach the
Cable inside the Left Leg (36) with aM10 x 70mm
Bolt (81), two M10 Washers (75), two Long
Spacers (80), and an M10 Nylon Locknut (70).
24.
Wrap the Leg Press Cable (95) around a 90mm
Pulley (38).
Attach the Pulley inside the Leg
Press Frame (30) with an M10 x 70mm Bolt (81),
two M10 Washers (75), two 13mm Spacers (34),
and an M10 Nylon Locknut (70).
22. Attach the end of the High Cable (45) to the
Small “U”-Bracket (79) with an M8 Washer (26)
and an M8 Nylon Locknut (71). Note: Do not
completely tighten the Nylon Locknut; it
should be threaded only two turns onto the
end of the Cable, as shown in the inset draw-
ing.
Attach the Small “U”-Bracket (79) to the Weight
Tube (82) with an M8 x 45mm Bolt (69) and an
M8 Nylon Locknut (71). Do not overtighten the
Locknut; the Weight Tube should be able to
pivot in the “U”-Bracket.
21. Wrap the High Cable (45) around a 90mm Pulley
(38). Attach the Pulley at the forward hole, inside
of the bracket on the Center
Top Frame (14) with
an M10 x 45mm Bolt (66) and an M10 Nylon
Locknut (70).
38
45
14
70
66
21
82
69
71
26
45
79
71
22
81
80
80
70
75
36
75
95
34
34
75
75
70
95
81
30
38
23
24
45
71