Filter
Top Products
75
5
Before beginning assembly, carefully read the
following information and instructions:
•
Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight system, make sure
all parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
An Allen wrench (included) and the following
tools (not included) are required for assembly:
• two adjustable wrenches
• one rubber mallet
• one standard screwdriver
• one Phillips screwdriver
• lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight system can be assembled suc-
cessfully by anyone. However, it is important to
realize that the versatile weight system has
many parts and that the assembly process will
take time. Most people find that by setting aside
plenty of time, assembly will go smoothly.
ASSEMBLY
1
33
33
81
67
1
70
81
67
28
75
75
57
57
1. Before beginning assembly, make sure that
you understand the information in the box
above.
Attach the Base Cap (28) to the Right Base (1)
with an M4 x 20mm Self-tapping Screw (77) and
an M5 Washer (50).
Attach the Center Base (67) to the Right Base (1)
with two M10 x 70mm Bolts (81), two M10
Washers (75), and two M10 Nylon Locknuts (70).
Do not tighten the Locknuts yet.
Insert four M10 x 65mm Carriage Bolts (57) up into
the Right Base (1).
2.
Press two 50mm Square Inner Caps (33) into the
Left Base (2).
Insert four M10 x 65mm Carriage Bolts (57) up into
the Left Base (2).
Attach the Left Base (2) to the Right Base (1) and
Center Base (67) with three M10 x 70mm Bolts
(81), three M10 Washers (75), and three M10
Nylon Locknuts (70).
Tighten the M10 Nylon Locknuts (70) used in
steps 1 and 2.
FRAME ASSEMBLY
2
1
2
81
70
57
77
50
75
57