Filter
Top Products
13
27. Attach the end of the Leg Press Cable (95) to the
“U”-Bracket (85) with an M8 Washer (26) and an
M8 Nylon Locknut (71). Note: Do not complete-
ly tighten the Locknut; it should be threaded
only two turns onto the end of the Cable, as
shown in the inset drawing.
28. Locate the Butterfly Cable (46). Attach the
Cable to the Pivot Bracket (48) on the Left
Butterfly Arm (10) with an M8 x 16mm Shoulder
Bolt (78) and an M8 Nylon Locknut (71).
26. Wrap the Leg Press Cable (95) around a 90mm
Pulley (38). Attach the Pulley inside the bracket
on the Left Top Frame (3) with an M10 x 45mm
Bolt (66) and an M10 Nylon Locknut (70).
25. Route the Leg Press Cable (95) through the Left
Leg (36) and the Left Upright (7) as shown. Wrap
the Cable around a 90mm Pulley (38).
Attach the
Pulley inside the Upright with an M10 x 70mm
Bolt (81), two M10 W
ashers (75), two 13mm
Spacers (34), and an M10 Nylon Locknut (70).
95
70
75
75
38
81
7
36
34
34
25
3
70
95
38
66
26
95
71
85
71
95
26
27
28
10
46
48
71
78