Filter
Top Products
8
8. Press a 1 3/4” Square Inner Cap (44) into the top
of a Press Arm (46). Press a 1” Round Inner Cap
(49) into the handle on the Press Arm.
Attach the Press Arm (46) to one side of the
Press Frame (17) with two 5/16” x 2 1/2” Bolts
(22) and two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same
manner.
9. Identify the Right Arm (48) and the Left Arm (47).
Note the position of the welded bracket on each
Arm. Arm identification is very important for
step 10.
Attach a “V”-Pulley (6) and a Long Cable Trap
(50) to the Right Arm (48) with a 3/8” x 2 1/2” Bolt
(7) and a 3/8” Nylon Locknut (21). Do not tighten
the Nylon Locknut yet.
Attach a “V”-Pulley (6) and a Long Cable Trap
(50) to the Left Arm (47) in the same way.
10. Lubricate both axles on the Top Frame (55). Slide
the Right Arm (48) onto the right axle. Note: Be
careful not to confuse the Right Arm with the
Left Arm (47); refer to step 9 to identify the
Right Arm. Make sure that the upper end of
the Right Arm is behind the indicated bracket
on the Top Frame.
Tap two 1” Retainers (69) and a 1” Round Cover
Cap (70) onto the right axle. Make sure that the
teeth on the Retainers bend toward the Cover
Cap, as shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press two 1 3/4” Square Inner Caps (44) into the
lower ends of the Right and Left Arms (47, 48).
Wet the lower end of each Arm with soapy water.
Slide a 10” Pad (45) onto the lower end of each
Arm.
10
50
50
46
46
3
22
17
44
49
Bracket
Lubricate
Axles
45
47
55
48
45
44
69
70
6
48
47
Welded
Brackets
21
21
8
9
69
55
70
7
6