Filter
Top Products
18
47
48
79
22
8
8
3
End must
slant this way
32
40
78
320 LB.
LEG
PRESS
34
34
34
30
30
29
80
30
28
45. Attach the Backrest (41) to the Front Upright (42)
with two 1/4” x 2 1/2” Screws (43) and two 1/4”
Washers (10).
46. Insert the 1/4” x 2 1/2” Carriage Bolt (38) into the
center hole in the Seat Plate (37). Attach the Seat
Plate to the Seat (13) with two 1/4” x 3/4” Screws
(18).
Insert the 1/4” x 2 1/2” Carriage Bolt (38) into the
indicated hole in the Seat Frame (36). Tighten a
1/4” Nylon Locknut (2) with a 1/4” Washer (10)
onto the Carriage Bolt.
Attach the other end of the Seat (13) to the Seat
Frame (36) with the 1/4” x 2 1/4” Screw (24) and
a 1/4” Washer (10).
47. Attach the Press Plate (78) to the Press Adjust-
ment Tube (79) with a 5/16” x 2 1/2” Bolt (22), two
5/16” Washers (8), and a 5/16” Nylon Locknut (3).
Align one set of holes in the Press Adjustment
Tube (79) with the holes in the Rocker Arm (32).
Insert the “L”-Pin (40) into the holes. Make sure
that the Press Adjustment Tube is oriented as
shown.
Apply the “320 LB. LEG PRESS” decal to the
center of the Press Plate (78) as shown.
48. Press a 3/4” Round Inner Cap (34) into each end
of the Short Pad Tube (28). Press a 3/4” Round
Inner Cap into each end of the Long Pad Tube
(80).
Insert the Short Pad Tube (28) into the Seat
Frame (36). Slide a 5 1/2” Pad (30) onto each
end of the Short Pad Tube.
Insert the Long Pad Tube (80) into the Leg Lever
(29). Slide a 5 1/2” Pad (30) onto each end of the
Long Pad Tube.
46
45
SEAT ASSEMBLY
41
42
10
43
2
24
36
13
37
18
38
10
10
36