Weider WESY19610 Home Gym User Manual


 
21
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If
there is slack in the cables before resistance is felt,
the cables should be tightened.
Refer to drawing 1. One way to remove slack from
the cables is to tighten the Resistance Cable (27) fur-
ther into the lower end of the Weight Tube (63).
Loosen the 1/2” Plane Nut (101) on the end of the
Cable. Tighten the bolt on the end of the Cable fur-
ther into the Weight Tube. Retighten the Plane Nut
against the Weight Tube.
Refer to drawing 2. Additional slack can be removed
by moving the indicated 3 1/2” Pulley (15) in the Long
“U”-Bracket (57). Remove the 3/8” x 2” Bolt (12), the
3/8” Nylon Locknut (21), the Pulley, and the Cable
Trap (66) from the Long “U”-Bracket. Reattach the
Pulley and the Cable Trap to the lower holes in the
Long “U”-Bracket with the Bolt and the Nylon Locknut.
Make sure that the Cable Trap is in the proper
position and that the Cable and Pulley move
smoothly.
Refer to drawing 3. Slack can also be removed by
moving the 3 1/2” Pulley (15) and the Cable Trap (66),
or the 4 1/2” Pulley (84) and the Metal Cable Trap
(97), to a set of holes closer to the center of the Pulley
Plates (20). To do this, remove the 3/8” x 2” Bolt (12),
the 3/8” Nylon Locknut (21), the Pulley, and the Cable
Trap from the Pulley Plates. Re-attach the Pulley and
the Cable Trap to a different set of holes with the Bolt
and the Nylon Locknut. Make sure that the Cable
Trap is in the proper position and that the Cable
and Pulley move smoothly.
Note: If a cable tends to slip off the pulleys often,
the cable may have become twisted. Remove the
cable and re-install it.
If the cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this
manual.
57
66
66
97
15
15
84
2
63
101
27
58
20
20
12
12
3
1
2
21
21
TROUBLE-SHOOTING AND MAINTENANCE
Make sure that all parts are properly tightened each time you use the weight system. Replace any worn parts
immediately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use
solvents.