Weider WESY19610 Home Gym User Manual


 
11
18. Route the High Cable (23) around a “V”- Pulley
(6). Attach the Pulley and a Long Cable Trap (50)
to the indicated bracket on the Rear Upright (56)
with a 3/8” x 2 1/2” Bolt (7) and a 3/8” Nylon
Locknut (21). Do not tighten the Nylon Locknut
yet. Make sure that the Cable Trap is turned to
hold the Cable in place.
19. Remove the 3/8” x 2” Bolt (12), the 3/8” Nylon
Locknut (21), the 3 1/2” Pulley (15), and the
Cable Trap (66) from the Pulley Plates (20).
Route the High Cable (23) around the Pulley as
shown, and then reattach the Pulley and the
Cable Trap to the Pulley Plates with the Bolt and
the Nylon Locknut. Make sure that the Bolt is
inserted into the indicated holes in the Pulley
Plates. In addition, make sure that the Cable is
in the groove of the Pulley and that the Cable
Trap is turned to hold the Cable in place.
20. Wrap the High Cable (23) over a 3 1/2” Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the indicated bracket on the Rear Upright (56)
with a 3/8” x 2” Bolt (12) and a 3/8” Nylon
Locknut (21). Make sure that the Cable Trap is
turned to hold the Cable in place.
21. Route the High Cable (23) over a 3 1/2” Pulley
(15). Attach the Pulley inside of the bracket on
the Top Frame (55) that is between the Weight
Guides (62) with a 3/8” x 2” Bolt (12) and a 3/8”
Nylon Locknut (21).
21
18
19
20
50
23
6
56
12
66
15
23
20
21
23
12
15
56
66
12
15
23
62
55
21
21
7
21