Filter
Top Products
12
22. Insert the end of the High Cable (23) into the
open end of the Weight Tube (63). Slide the
Plastic Stabilizer (67) onto a 5/16” x 1 3/4” Bolt
(72). Then, insert the Bolt into the hole near the
top of the Weight Tube and through the end of
the High Cable. Tighten a 5/16” Nylon Locknut (3)
onto the Bolt. Make sure that the Plastic
Stabilizer is wrapped around the Weight Tube.
Insert the Weight Tube (63) into the center holes
in the stack of Weights (25).
23. Identify the Low Cable (19). Wrap the Low
Cable under the 3 1/2” Pro Pulley (77). Attach the
Pulley to the Rocker Arm (32) with a 3/8” x 3 1/2”
Bolt (16), a 3/8” Washer (9), and a 3/8” Nylon
Locknut (21). Make sure that the end of the
Cable with the ball is on the indicated side of
the Pro Pulley and that the Cable is between
the Pro Pulley and the hook on the Rocker
Arm.
24. Route the Low Cable (19) under the crossbar on
the Press Frame (17).
Wrap the Low Cable (19) around a 3 1/2” Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the indicated side of the Rear Upright (56) with a
3/8” x 6” Bolt (64). Make sure that the Cable
Trap is turned to hold the Cable in place.
Slide another 3 1/2” Pulley (15) and Cable Trap
(66) onto the end of the 3/8” x 6” Bolt (64). Hand
tighten a 3/8” Nylon Locknut (21) onto the Bolt.
22
23
24
23
77
19
21
19
66
15
56
66
15
17
Crossbar
21
67
63
3
72
25
16
9
Hook
32
64