Filter
Top Products
58
58
57
57
10
2
2
15
15
33. Route the Press Cable (58) between the indicat-
ed 3 1/2” Pulley (15) and the Cable Trap (66)
attached to the Rear Upright (56). Make sure
that the Cable Trap is turned to hold the Cable
in place. Properly tighten the 3/8” Nylon Locknut
(21).
34. Attach the end of the Press Cable (58) to the
Long “U”-Bracket (57) with a 1/4” Nylon Locknut
(2) and a 1/4” Washer (10) (see the inset draw-
ing). Do not completely tighten the Nylon
Locknut; it should be threaded onto the end
of the Cable until only two threads are show-
ing above the Nylon Locknut, as shown in the
inset drawing. Note: It may be necessary to
remove the 3 1/2” Pulley (15) from the Long
“U”-Bracket to do this step.
35. Attach the Resistance Bracket (35) inside of the
upper bracket on the Front Upright (42) with a
3/8” x 2 1/4” Bolt (14) and a 3/8” Nylon Locknut
(21). Do not overtighten the Nylon Locknut;
the Bracket must be able to pivot easily.
See the inset drawing. Remove the indicated
3/8” x 1 1/4” Bolt (83) and 3/8” Nylon Jamnut (33)
from the Resistance Handle (88). Attach the
Cylinder (89) to the Resistance Handle with the
Bolt and the Nylon Jamnut.
Note: The Cylinder (89) should be turned so
that the decal is on the same side as the knob
on the Resistance Handle (88).
36. Pull out the knob on the Resistance Handle (88)
as far as it will go. Slide the Resistance Handle
onto the Resistance Bracket (35) and release the
knob so that the pin on the knob is inserted into
the upper adjustment hole in the Resistance
Bracket. Tighten the four Nylon Jamnuts (not
shown) on the Handle. Note: Do not overtighten
the Nylon Jamnuts; the Handle must be able
to slide across the Bracket easily.
Attach the Cylinder (89) and two 5/8” x 7/8”
Spacers (61) inside of the lower bracket on the
Front Upright (42) with a 3/8” x 3 1/4” Bolt (68)
and a 3/8” Nylon Locknut (21) (refer to the inset
drawing).
33
34
35
36
35
14
21
42
42
61
61
21
35
88
89
58
15
56
21
66
68
Knob
68
89
21
61
33
83
89
Decal
Knob
88