Weider WESY19610 Home Gym User Manual


 
17
98
4
27
41. Attach two 3 1/2” Pulleys (15) and two Cable
Traps (66) to the end of the Resistance Bracket
(35) as shown with a 3/8” x 3” Bolt (93) and a 3/8”
Nylon Jamnut (33). Do not tighten the Nylon
Jamnut yet. Make sure the Pulleys and Cable
Traps are oriented as shown.
Route the Resistance Cable (27) over the indicat-
ed 3 1/2” Pulley (15). Make sure that the Cable
is between the Pulley and the Cable Trap (66),
and that the Cable Trap is turned to hold the
Cable in place.
42. Pull the indicated
3/8” x 3” Grade 5 Bolt (98) out
of the wide bracket on the Base (4) until you can
remove the indicated 3 1/2” Pulley (15). Wrap the
Resistance Cable (27) up around the Pulley and
then fully reinsert the Bolt.
43. Route the Resistance Cable (27) over the other
3 1/2” Pulley (15) on the Resistance Bracket (35).
Make sure that the Cable is between the
Pulley and the Cable Trap (66), and that the
Cable Trap is turned to hold the Cable in
place.
Refer to step 41. Tighten the 3/8” Nylon
Jamnut (33).
44. Slide the end of the Resistance Cable (27) onto
the indicated 3/8” x 3” Grade 5 Bolt (98), on the
outside of the wide bracket on the Base (4).
Note: Be sure the Resistance Cable is on the
inside of the Press Cable (58).
Tighten a 3/8” Nylon Jamnut (33) onto the
3/8” x
3” Grade 5 Bolt
(98). Do not overtighten the
Nylon Jamnut; the Cable must be able to pivot
freely.
41
42
43
44
15
27
35
66
98
27
58
33
93
15
15
33
27
66
35
4
66
15