Filter
Top Products
9
10. Lubricate both axles on the Top Frame (10).
Slide the Right Arm (12) onto the right axle on the
Top Frame (10). Note: Be careful not to con-
fuse the Right Arm with the Left Arm (11);
refer to step 9 to identify the Right Arm. Be
sure that the upper end of the Right Arm is
behind the indicated bracket on the Top
Frame.
Place two 1” Retainers (48) on top of a 1” Round
Cover Cap (49), as shown in the inset drawing.
Be sure that the teeth on the Retainers bend
toward the Cover Cap. Tap the Cover Cap and
Retainers onto the right axle.
Attach the Left Arm (11) in the same manner.
11. Press four 1 1/2” x 2” Inner Caps (52) into the
ends of the Punching Bag Arm (6) and the Speed
Bag Arm (7).
Attach a 3/8” x 2” Eyebolt (64) to the Punching
Bag Arm (6) with two 3/8” Washers (86) and a
3/8” Nylon Locknut (84).
12. Attach the Speed Bag Board (33) to the Speed
Bag Arm (7) with four 3/8” x 1” Bolts (89) and four
3/8” Nylon Jamnuts (92).
10
11
12
Bracket
Lubricate
Axle
10
11
12
48
49
48
10
49
6
52
7
92
33
89
89
52
64
84
86
86
52
52
7