Filter
Top Products
7
5. Press two 2” Square Inner Caps (55) into the
ends of the Top Frame (10). Press a 1 3/4”
Square Inner Cap (56) into each end of the cross-
bar on the Top Frame. Press two Round Inner
Caps (59) into the top of the crossbar.
Attach the Top Frame (10) to the Front Upright (4)
and the Rear Upright (5) with four 5/16” x
2 3/4” Bolts (73), four 5/16” Washers (85), and
four 5/16” Nylon Locknuts (83).
Tighten the 5/16” Nylon Locknuts (83) used in
steps 4 and 5.
4. Press a 1” Square Inner Cap (53) into the Front
Upright (4).
Slide the Front Upright (4) onto the 5/16” x 2 1/2”
Carriage Bolts (65) in the Base (2). Hand tighten
two 5/16” Nylon Locknuts (83) onto the Carriage
Bolts. Do not tighten the Nylon Locknuts yet.
4
3
3. Slide the nine Weights (22) onto the Weight
Guides (9). Be sure that all of the Weights are
turned so the large pin grooves are on the bottom
of the Weights and on the front of the weight stack.
Press the Weight Tube Bumper (27) into the end
of the Weight Tube (26). Insert the Weight Tube
into the stack of Weights (22). Be sure that the
pins on the Weight Tube are resting in the pin
grooves in the upper Weight.
Lubricate the insides of the holes in the Top
Weight (24). Slide the Top Weight onto the
Weight Guides (9).
5
Lubricate
Pin
Groove
Pin
24
9
26
22
27
56
55
55
10
59
73
73
4
53
83
65
2
85
85
85
56
83
83
4
5
Crossbar