Filter
Top Products
8
6. Attach the upper ends of the Weight Guides (9) to
the Top Frame (10) with the 5/16” x 6” Bolt (91),
two 1/2” x 3/4” Spacers (39), and a 5/16” Nylon
Locknut (83).
See the inset drawing. Be sure that the Pulley
Bracket (51) is in front of the right Weight
Guide (9).
7
6
9
83
84
40
2
83
12
11
62
62
56
56
80
13
14
14
61
56
71
13
10
39
91
Tube
Welded
Spacers
Lubricate
Holes
Arm Assembly
7. Press a 1” x 7/8” Plastic Bushing (40) onto each
welded spacer on the Press Frame (13). Slide the
Press Frame into place on the Base (2). Note:
This will be a tight fit. The Plastic Bushings
should fit onto each end of the indicated tube
in the Base. Be sure that the holes are on the
indicated side of the Press Frame.
Lubricate the 3/8” x 8” Bolt (71). Attach the Press
Frame (13) to the Base (2) with the Bolt and a
3/8” Nylon Locknut (84). Do not overtighten the
Nylon Locknut; the Press Frame must be able
to pivot freely.
8. Press a 1 3/4” Square Inner Cap (56) into the top
of a Press Arm (14). Press a 1” Round Inner Cap
(61) into the end of the handle on the Press Arm.
Attach the Press Arm (14) to one side of the
Press Frame (13) with two 5/16” x 2 1/2” Bolts
(80) and two 5/16” Nylon Locknuts (83).
Assemble the other Press Arm (14) in the same
manner.
9. Identify the Left Arm (11) and the Right Arm (12).
Note the position of the welded bracket on each
Arm. Arm identification is very important for
step 10.
Press 1 3/4” Square Inner Caps (56) into the
lower ends of the Left and Right Arms (11, 12).
Wet the end of each Arm with soapy water, and
slide a 10” Pad (62) onto each Arm.
Welded
Brackets
8
9
9
51