Filter
Top Products
9
42
42
95
87
120
9. Insert the ends of two Weight Guides (42) into the
indicated bracket on the Long Base (120). Attach
the Weight Guides to the Long Base with a 3/8” x
6 1/2” Bolt (95) and a 3/8” Nylon Locknut (87).
Attach the other two Weight Guides (42) to the
Long Base (120) in the same way.
10. Slide two Weight Bumpers (49) onto the two indi-
cated Weight Guides (42). Next, slide ten Weights
(44) onto the Weight Guides.
Make sure that the
Weights are turned so the grooved sides of the
Weights are facing downward.
Press a Weight Tube Bumper (48) into the lower
end of a Weight Tube (43). Insert the Weight Tube
into the centers of the Weights (44). Make sure
that the Weight Tube is turned as shown.
Lubricate the two outer holes in a Top Weight (45).
Slide the Top Weight onto the Weight Guides (42).
Make sure that the Top Weight is turned so the
grooved side is facing downward.
Apply a number “10” decal to the Top Weight (45) in
the location shown. Apply decals with the numbers
20 through 110 to the ten Weights (44).
Assemble the other weight stack in the same
way.
11. Attach the Top Frame (6) between the Squat
Upright (4) and the VKR Upright (5) with four 5/16”
x 3 3/4” Bolts (92), the two Short Frame Plates (52),
and two 5/16” Nylon Locknuts (86) as shown.
Do
not tighten the Bolts and Nylon Locknuts yet.
Attach the four Weight Guides (42) to the Top
Frame (6) with two 3/8” x 6 1/2” Bolts (95) and two
3/8” Nylon Locknuts (87).
9
10
49
Grooves
Lubricate
43
48
42
45
44
“10” Decal
“20” Decal
“110” Decal
11
6
86
86
4
5
95
95
87
42
87
52
92
52
92
42