Filter
Top Products
21
56
57
58
114
114
12
17
56. Attach the Squat Arm (32) to the Squat Bracket (37)
with two 3/8” x 2 1/2” Carriage Bolts (106), two 3/8”
Washers (91), and two 3/8” Nylon Locknuts (87).
Do not tighten the Nylon Locknuts yet.
Finish attaching the Squat Arm (32) to the Squat
Bracket (37) with a 3/8” x 3” Bolt (107), a 3/8”
Washer (91), and a 3/8” Nylon Locknut (87).
Tighten all of the 3/8” Nylon Locknuts (87) used
in this step.
57. Attach the Squat Backrest (35) to the Squat Bracket
(37) with four 1/4” x 3/4” Screws (114).
Turn the indicated Adjustment Handle (65) counter-
clockwise several turns to loosen it. Next, pull the
Handle and slide the Squat Bracket (37) down onto
the Squat Slider (38). Engage the Handle into one
of the holes in the Squat Slider, and then turn the
Handle clockwise until it is tight.
58. Attach the Curl Pad (17) to the Curl Frame (12) with
two 1/4” x 3/4” Screws (114).
59. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on page 22 of this manual.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAMS on page 26 and 27 of this manual for proper cable routing. If there is any slack in
the cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING on
page 25.
35
37
38
65
114
114
91
87
32
106
37
91
107
87