Filter
Top Products
12
20. Remove the preattached 3 1/2” Pulleys (78 [only
one is shown]) from the Offset Double “U”-
bracket (61).
Wrap the VKR High Cable (74) under a 3 1/2”
Pulley (78). Attach the Pulley to the Offset Double
“U”-bracket (61) with a 3/8” x 1 3/4” Bolt (93) and a
3/8” Nylon Locknut (87).
21. Wrap the VKR High Cable (74) over a 4 1/2” Pulley
(119). Attach the Pulley inside of the indicated
bracket on the Top Frame (6) with 3/8” x 1 3/4” Bolt
(93) and a 3/8” Nylon Locknut (87).
22. Place a 1/2” Washer (1) on top of the Weight Tube
(43) closest to the VKR Upright (5).
Tighten a 1/2” Nut (118) halfway onto the end of the
VKR High Cable (74). Screw the end of the Cable
two full turns into the Weight Tube (43). Then, tighten
the Nut against the 1/2” Washer (1).
23. Locate the Lat Cable (88), which is 89 1/4” long
and has an eyelet on one end and a ball on the
other end.
Route the eyelet end of the Cable up
through the Butterfly Top Frame (7) and around a
3 1/2” Pulley (78). Attach the Pulley inside of the
Butterfly Top Frame with a 3/8” x 2 3/4” Bolt (101),
two 3/8” Washers (91), two 1/2” Spacers (89), and
a 3/8” Nylon Locknut (87).
23
20
21
22
74
118
1
43
5
93
78
87
61
74
119
6
87
93
74
78
89
91
87
91
88
101
7