Filter
Top Products
9
12
48
21
50
7
6
58
12. Route the Long Cable (58) around a “V”-Pulley
(6). Attach the Pulley and the Long Cable Trap
(50) to the Right Arm (48) with an M10 x 60mm
Bolt (7) and an M10 Nylon Locknut (21). Be sure
that the Cable is in the groove of the Pulley
and that a Long Cable Trap (50) is turned to
hold the Cable in place.
13. Refer to the inset drawing. Attach the Pulley
Bracket (20) to the bracket on the Top Frame (55)
with an M8 x 115mm Bolt (64) and an M8 Nylon
Locknut (3). Note: The Pulley Bracket is pre-
assembled with a 90mm Pulley (15) and a
Cable Trap (66).
Route the Long Cable (58) around the 90mm
Pulley (15) attached to the Pulley Bracket (20).
Be sure that the Cable is in the groove of the
Pulley and that the Cable Trap (66) is turned
to hold the Cable in place. Make sure that the
M10 x 45mm Bolt (12), securing the Pulley and
Cable Trap to the Pulley Bracket, is properly tight-
ened and that the Pulley Bracket can pivot freely.
14. Locate the Long “U”-Bracket (57). Route the Long
Cable (58) between the 90mm Pulley (15) and
the Cable Trap (not shown) attached to the Long
“U”-Bracket with an M10 x 45mm Bolt (12) and an
M10 Nylon Locknut (not shown). Be sure that
the Cable is in the groove of the Pulley, that
the Cable Trap is turned to hold the Cable in
place, and that the Cable and Pulley move
smoothly.
15. Route the Long Cable (58) around a 90mm Pulley
(15). Attach the Pulley to the bracket on the Top
Frame (55) with an M10 x 45mm Bolt (12) and an
M10 Nylon Locknut (21). Be sure that the Cable
is in the groove of the Pulley and that the
Cable and Pulley move smoothly.
13
58
66
15
12
20
64
55
3
20
14
58
57
12
15
15
12
15
58
Bracket
55
21