Filter
Top Products
14
27. Press two 19mm Round Inner Caps (34) into the
ends of both Pad Tubes (28).
Insert one Pad Tube (28) into the Seat Frame
(36). Slide a Foam Pad (30) onto each end of the
Pad Tube.
Insert the other Pad Tube (28) into the Leg Lever
(29). Slide a Foam Pad (30) onto each end of the
Pad Tube.
28. Make sure that all parts have been properly tightened. The use of all remaining parts will be explained in
ADJUSTMENT, beginning on page 15 of this manual.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If
the cables are not properly routed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAM on page 19 of this manual for proper cable routing. If there is any slack in the
cables, you will need to remove it by tightening the cables; see TROUBLE-SHOOTING AND MAINTE-
NANCE on page 18.
27
30
34
28
34
29
30
36